Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 241)

Scanning Features

Product Reference Guide

231

Aiming Duration Time

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger

single mode. The range for this setting is from 1 to 255 seconds in 1-second increments.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20

= 02

0, etc.

3. Go to page 72 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT AIMING DURATION TIME SETTING.

5. Scan the appropriate three digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 40 for some examples of how to set this feature.

Table 40. Aiming Duration Time Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

1 Second 90 Sec. (1.5 min.) 180 Sec. (3 min.) 255 Seconds (4.25 min.)

2 Pad leading zero(es)

001 090 180 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT AIMING DURATION TIME SETTING

Scan Three Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘1’ ‘0’, ‘9’ and ‘0’ ‘1’, ‘8’ and ‘0’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 283 284

Brak uwag

Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Strona 241