Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 217)

RS-232 Parameters

Product Reference Guide

207

RS-232/USB COM Parameters

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

To set the delay:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

4. Go to page 25 and scan the barcode: SELECT INTERCHARACTER DELAY SET-

TING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.

This completes the procedure. See Table 25 for some examples of how to set this feature.

Table 25. Intercharacter Delay Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

50ms 150ms 600ms 850ms

Divide by 10 (pad with leading

zer

oes to yield two-digits)

05 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCHARACTER DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 283 284

Brak uwag

Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Strona 217