Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 221)

RS-232 Parameters

Product Reference Guide

211

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label transmission due to a retry

condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and

a selection of 255 specifies unlimited retries.

To set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005,

= 0

20, etc.

3. Go to page 28 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT ACK NAK RETRY COUNT SETTING.

5. Scan the appropriate three digits from the keypad in Appendix D, Keypad, that represent

the number which was determined in the steps abo

e. You will hear a two-beep indication

after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 29 for some examples of how to set this feature.

Table 29. ACK NAK Retry Count Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

Disable Retry

Count

3 Retries 54 Retries Unlimited Retries

2 Pad with leading zero(es)

000 003 054 255

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT ACK NAK RETRY COUNT SETTING

Scan Three Characters From

Appendix D, Keypad

‘0’, ‘0’ and ‘0’ ‘0’, ‘0’ and ‘3’ ‘0’, ‘5’ and ‘4’ ‘2’, ‘5’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 283 284

Brak uwag

Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Strona 221