Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 228)

References

218

WDI4600

4. Scan the appropriate two digits from the keypad in Appendix D, Keypad that represent

the length setting which was determined in the st

eps above. You will hear a two-beep indi-

cation after the last character.

If you make a mistake, before the last character scan the CANCEL barcode

to abort and not save the entry string. You can then start again at the

beginning.

5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure.

Data Editing

When a barcode is scanned, additional information can be sent to the host computer along with

the barcode data. This combination of barcode data and supplementary user-defined data is

called a “message string.” The Data Editing features can be used to build specific user-defined

data into a message string.

There are several types of selectable data characters that can be sent before and after

scanned

data. You can specify if they should be sent with all symbologies, or only with specific

symbologies. Figure 6 shows the available elements you can add to a message string:

Figure 6. Breakdown of a Message String

Prefix SuffixAIM IDLabel ID Label IDBar Code Data

00 - 20 Characters (ASCII)

Label ID Transmission:

Enable this option to

transmit the Label ID you

configure for the scanned

symbology.

AIM ID: This function is used to identify and display the

common label identifier for its symbology. When enabled,

this ID code will be transmitted before the scanned bar

code data.

OR...

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 283 284

Brak uwag

Wasp-barcode WDI4600 2D Product Reference Guide Instrukcja Użytkownika Strona 228