Wasp-barcode WLS9600 Product Reference Guide Instrukcja Użytkownika Pobierz pdf (Strona 73)

ENTER/EXIT PROGRAMMING MODE Set Global Mid Label ID Characters

Product Reference Guide 63

Label ID Symbology Selection (continued)

Set Anker Plessey Label ID Character(s)

Set Code 4 Label ID Character(s)

Set Code 5 Label ID Character(s)

Set Global Mid Label ID Characters

Specifies mid-label ID that is added for transmission between the labels of a two-label pair.

To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above

to place the unit in Pr

ogramming Mode, then the “Set Global Mid Label ID Character(s)”

barcode followed by the digits (in hex) from the Alphanumeric characters in Appendix D, Keypad

representing your desired character(s). If less than the expe

cted string of 20 characters are

selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode by

scanning the ENTER/EXIT barcode again.

Set Global Mid Label ID Character(s)

Make a mistake? Scan the CANCEL barcode to abort and not

save the entry string. You can then start again at the beginning.

CANCEL

DEFAULT

No Mid Label ID

Character (00)

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 305 306

Brak uwag

Wasp-barcode WLS9600 Product Reference Guide Instrukcja Użytkownika Strona 73